Pneumatic Rhino Post Driver

The Rhino driver is powered by a 185cfm air compressor and 3/4″ air hose and will drive up to a 3″ fence post in seconds.  Check out this video

185 CFM Airman Air Compressor

The 185 CFM air compressor is towed with a 2″, 2 5/16″, or a pintle hitch.  It is equipped with three 3/4″ Chicago fittings.  It will put out up to 140 psi and can be adjusted down for different jobs.

6-10 CFM Gas Air Compressor

The 6-10 CFM air compressor uses a 3/8″ hose and runs off of a Honda engine.  It is used when you need to run more than one tool or if the tool requires more CFM.

6-10 CFM Electric Air Compressor

The 6-10 CFM air compressor uses a 3/8″ hose and runs off of a standard outlet.  It is used when you need to run more than one tool or if the tool requires more CFM.

2-3 CFM Electric Air Compressor

The 2-3 CFM air compressor uses a 3/8″ hose and runs off of a standard outlet.

 

Air Scaler

The pogo stick runs off of a 3/4″ hose and is perfect for removal of ceramic tile or mastic.

90 lbs. Air Breaker

The 90 lbs. breaker attaches to a 3/4″ hose and must be run off of a 185 CFM air compressor.  It comes with a point and chisel bit.

65 lbs. Air Breaker

The 65 lbs. breaker attaches to a 3/4″ hose and must be run off of a 185 CFM air compressor.  It comes with a point and chisel bit.

30 lbs. Air Breaker

The 30 lbs. breaker attaches to a 3/4″ hose and must be run off of a 185 CFM air compressor.  It comes with a point and chisel bit.

20 lbs. Chipping Hammer

The chipping hammer attaches to a 3/4″ hose and must be run off of a 185 CFM air compressor.  It comes with a point and chisel bit.